DLMS meter for large consumers
You read a DLMS meter for large consumers with an optical DLMS sensor. You place it on the optical port of the meter. This port must be enabled by the metering company. In some cases, the meter does not output any (useful) data, and the metering company can configure the correct data.
To monitor a DLMS meter, you need the DLMS monitoring module. Go to Settings › Modules and activate the module.
Connecting
- Place the DLMS sensor on the optical port of the meter.
- Connect the USB cable of the sensor to a USB port of the CEMM.
Adding the meter
- In the portal or the app, go to Settings › Meters and click Add meter.
- Choose Smart meter and then DLMS.
- Complete the steps in the wizard.
After adding the meter, you still need to specify which data should be logged. Go to Settings › Meters and open the Settings of the DLMS meter. The Extensions block shows which data the meter outputs. Select the power, energy and other values you want to log and click Apply.
If the list of extensions is empty, this may be caused by the configuration, the connection of the sensor or the meter itself. Check the meter status on the Settings › Meters page. If the status is green, the meter is not outputting enough data. In that case, contact the metering company.
Still stuck? Contact support