Teracom TDI340
With a Teracom TDI340, you can connect more pulse meters or sensors than the three that fit directly on the CEMM. The TDI340 has four inputs and communicates with the CEMM via Modbus.
For this you need:
- A Teracom TDI340.
- The Teracom software module for the CEMM. You activate it with an activation code.
- A Modbus bus between the CEMM and the TDI340. How to connect a Modbus bus.
Connecting
- Connect the pulse meters to inputs S0 to S3 of the TDI340. One TDI340 takes four.
- Connect the TDI340 to the Modbus bus.
- Connect the power supply of the TDI340, for example by using this Modbus converter.
Your situationI have more than four pulse meters
Connect a second TDI340 to the same Modbus bus. Each TDI340 has its own Modbus address, which you can find on the sticker on the device.
Adding the meter
- Activate the Teracom software module with your activation code, if you have not done so already.
- In the portal or the app, go to Settings › Meters and click Add meter.
- Choose Modbus RTU meter and then the Teracom TDI340.
- Enter the Modbus address. You can find it on the sticker on the TDI340.
- Choose the input the pulse meter is connected to: S0, S1, S2 or S3.
- Complete the rest of the wizard.
Repeat these steps for each pulse meter on the TDI340.
Setting the pulse rate and meter reading
After the wizard, set the pulse rate and the meter reading for each input. Without the correct pulse rate, the consumption and the meter reading will be incorrect.
- Go to Settings › Meters and click Settings next to the meter.
- Open the Device settings and go to the Teracom TDI340 tab.
- Enter the pulse rate for each input. You can find it on the meter, for example 1000 imp/kWh.
- Enter the current meter reading for each input.
The CEMM sends these settings directly to the TDI340.
Problem?The CEMM cannot find the TDI340
- Check that the TDI340 has power.
- Check the wiring of the Modbus bus. See the instructions for the Modbus bus.
- Check that the Modbus address in the wizard matches the address on the sticker of the TDI340.
- Check that the Teracom software module has been activated.
Still stuck? Contact support